STM32

Wide box Tiny box List
Ascent Descent

Using DHT11 with ChibiOS/RT

Using DHT11 with ChibiOS/RT

The DHT11 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed).

The communication on data pin occurs according to a non-standard protocol known as One-Wire protocol.

In this article we want to provide a demonstration for DHT11 compatible with ChibiOS/HAL 3.0, but also explain concepts inside that demo. Following that purpose we need for the DHT11 datasheet.

DHT11 Datasheet

Typical circuit requires a continue reading...

ChibiCube hardware explained

ChibiCube hardware explained

By this article, we will show schematic of ChibiCube in order to understand how it works and hot it has been designed.

As mentioned in the previous article, ChibiCube addresses all its LEDs through the combination of anode and cathode signals. Each floor of the cube is configured as common anode, while the various cathode signals are separately connected to the outputs of the Shift Register. Setting the anode voltage to a value equal or greater than the high logical threshold of our SR, for the same principle illustrated in the tutorial Meeting SPI, we can address single continue reading...

Introducing ChibiCube

Introducing ChibiCube

ChibiCube is a 3D LED matrix 8x8x8 composed by monochromatic LEDs individually addressable: that means not only every single LED could be in a ON or OFF state but everyone could be set at different light intensity.

In December 2012, students Ciro Domenico Pagano from University of Salerno, Antonio Galano from Federico II University of Naples and Vincenzo Brillante from University of Sannio start their training at Naples site of ST Microelectronics.

In order to understand uses of ChibiOS and STM32 MCUs, their Tutor Giovanni Di Sirio suggested the design of a small 4x4x4 continue reading...